AOKI blow molding heating lamp

Mon, 01 Jun 2026 23:13:58 +0800

On the floor, an AOKI stretch blow molder has zero patience for uneven preform heating. If the heating lamp output starts drifting, you’re staring down thin walls, crystallized shoulders, and a line that keeps stopping to chase rejects. We built this AOKI blow molding heating lamp to swap in for the OEM unit without the guesswork—same mounting, same interface, and repeatable radiant output. What matters, technically It’s a short-wave infrared lamp, built for AOKI blow molding machines. Halogen emitter, quartz envelope—fast response, tight control inside the heating tunnel. We match the original wattage, voltage, base type, and overall envelope, so it drops straight into the existing holder. No brackets. No rewiring. No re-tuning the heating profile from scratch. The filament geometry and reflector layout are set to focus heat on the preform neck and body, so you get consistent material temperature across the cavity. Why it holds up on an AOKI AOKI cycles are tight, and preform heating has to keep up. With this lamp, warm-up after startup is quicker, and recovery after a jam clear is faster—fewer short-shots, less scrap. Energy stays in line because output is stable and the lamp hits setpoint without overshooting. In practice, that means more uptime, fewer lamp changes, and a heating curve you can lock in per SKU. A few shop-floor notes Installation is straightforward on AOKI blow molders, but the heating tunnel is brutal on components. Keep the lamp aligned in the holder, and check reflector cleanliness at changeover. Use the correct voltage, and make sure the terminal connection is tight—loose contacts give you flicker and drift. Also, verify lamp length and end fit against your specific machine version so it doesn’t contact adjacent parts. Match the specs, and it runs as a direct, dependable replacement.

AOKI on Premium Gold IR Heating

AOKI blow molding heating lamp