Global supply of blow molding heaters

Tue, 21 Jul 2026 05:21:33 +0800

Stop Replacing Your SIG Blomax Lamps Every Other Week

If your SIG Blomax line is eating through heating lamps, you probably already know the frustration. You swap one out, everything runs fine for a bit, and then—pop—another one goes. Here’s the thing: it’s usually not the lamp’s fault. It’s the stress. High-speed PET lines vibrate and heat up and cool down constantly. Standard heaters just aren’t built for that kind of abuse. That’s why we make reinforced replacements. We wanted to build something that actually lasts so you can stop dealing with constant downtime. Why they actually break Quartz is brittle. Simple as that. In a Blomax setup, the points where the lamp touches the machine are under a lot of pressure. That’s where the cracks start. We fixed this by beefing up the structural integrity of the tube and the electrode seal. We tweaked the wall thickness and the way the filaments are welded to move the breaking point way further down the road. And the best part? They’re drop-in replacements. You won’t have to mess with your wiring or change your layout. It just works. The heat struggle We all want faster cycle times, which means more wattage. But cranking up the heat puts a massive load on the quartz. To handle this, we use specific coatings that manage the infrared spectrum. This means the PET preform gets the energy it needs, but the lamp housing doesn’t overheat. Just a heads-up, though: if you run your lamps at the absolute limit of their spec, they’re going to wear out faster. It’s a trade-off. If you can balance your oven temp with your line speed, you’ll get way more hours out of the part. A fit that actually fits There’s nothing worse than a technician trying to jam an off-spec tube into a tight bracket. That forcing is what causes those tiny micro-fractures that lead to an early burnout. We spec our heaters to match the original SIG dimensions exactly. They slide right into the holders. No forcing, no fighting with the hardware. Stop the cycle of replacing the same lamp every few weeks. Switch to a build that can actually take a beating.

Global exporter of PET preform heaters

Sun, 19 Jul 2026 20:24:54 +0800

Getting your Sidel PET heaters to actually fit

We make infrared heating elements for Sidel blowing machines. Whether you’re still running the old SBO series or you’ve moved up to the Matrix lines, we’ve got you covered. The goal here is simple:drop-in replacement. You shouldn’t have to spend your weekend modifying oven frames or messing around with the wiring in your panels just to get a lamp to turn on. It should just work.

The headache of “almost” fitting

Here’s the thing about Sidel systems—they’ve changed a lot over the years. Going from an SBO to a Matrix meant changes in lamp size, wattage, and how the connectors fit. If a lamp is off by even a single millimeter, you’re in trouble. It either won’t click into the socket, or it’ll vibrate during a high-speed run and crack. That’s a nightmare you don’t need. We obsess over the specs. We match the length and the electrical load of the OEM lamps exactly. This means the heaters sit snugly in the reflectors without putting any weird pressure on the quartz glass. No custom adapters. No guesswork.

Heaters on Premium Gold IR Heating

Global supply of blow molding heaters

Stop Replacing Your SIG Blomax Lamps Every Other Week

Global exporter of PET preform heaters

Getting your Sidel PET heaters to actually fit

The headache of “almost” fitting